LX-2
Passive balanced line-level splitter with a Jensen transformer that sends one audio signal to two destinations and isolates them to remove ground-loop hum. A switchable trim control attenuates hot signals, suited to studio and stage use.
- Passive balanced line-level splitter, one input to two outputs
- Jensen transformer isolates the two outputs
- Eliminates hum and buzz from ground loops
- Variable trim control attenuates hot signals
- Recessed set-and-forget switch engages the trim
- Part no: R800 1033 00
Kuvat
8Ilmoitukset
Tästä mallista ei vielä ole ilmoituksia
Kun joku myy mallin LX-2, ilmoitukset ja myyntihistoria näkyvät täällä.
Myy samanlainenKuvaus
The LX-2 is a passive splitter for balanced line-level audio. It feeds one source to two separate destinations, for example a recording interface and a PA system, while a Jensen transformer isolates the two outputs from each other. This isolation removes hum and buzz caused by ground loops.
A trim control attenuates signals that are too hot. It allows a mic preamp to be driven hard for coloration while the level is reduced before it reaches an interface or compressor input, avoiding clipping. The trim is enabled by a recessed switch intended for set-and-forget use. With the switch off, the control is bypassed and the level cannot be changed by accident.
Typical uses include splitting a preamp output to two compressors, sending a line output both to stage PA and to a recorder, and feeding an outboard effects unit alongside a clean signal to the interface so the two can be blended in a DAW for parallel processing.
Video
Tekniset tiedot
- Merkki
- Radial Engineering
- Malli
- LX-2
- Luokka
- Studio › Esivahvistimet ja outboard-laitteet
Audio
- Type
- Passive balanced line-level splitter and attenuator
- Transformer
- Jensen
- Number of outputs
- 2
- Output isolation
- Transformer-isolated outputs
- Ground loop hum and buzz
- Eliminated
Controls
- Level control
- Variable trim control (attenuation)
- Trim engage switch
- Recessed set and forget switch
- Trim bypass
- Disengage switch when attenuation not needed
Power
- Power
- Passive (no power required)
Applications
- Live
- Split line outputs on stage to recording interface and PA
- Studio
- Split a mic preamp output to two compressors
- Parallel processing
- Feed outboard effects and a clean signal to the interface
Identification
- Maker
- Radial Engineering
- Model
- LX-2
- Part number
- R800 1033 00