Battalion
Analog bass preamp and DI pedal with a four-band EQ, a MOSFET distortion section with blend control, a compressor and a noise gate. It suits bassists who want tone shaping, a balanced XLR feed and effects in one pedalboard unit.
- Four-band bass EQ: 200 Hz, 280 Hz, 750 Hz and 2 kHz bands
- MOSFET distortion with Level, Blend, Drive, Tone and own footswitch
- Pre EQ, Post EQ and Dry EQ distortion routing switch
- Compressor and noise gate with adjustable threshold
- Balanced XLR out with volume knob and ground lift
- Switchable 10 dB input pad; power adapter included
Kuvat
7Ilmoitukset
Tästä mallista ei vielä ole ilmoituksia
Kun joku myy mallin Battalion, ilmoitukset ja myyntihistoria näkyvät täällä.
Myy samanlainenKuvaus
The Battalion combines several bass processing stages in one pedal. A four-band EQ covers bass (below 200 Hz), low mid (boost/cut at 280 Hz), high mid (boost/cut at 750 Hz) and treble (boost/cut above 2 kHz). A compressor with its own pushbutton, amount knob and LED adds sustain and thump, and a noise gate with an adjustable threshold reduces noise and hum.
The MOSFET distortion section has Level, Blend, Drive and Tone controls and its own footswitch. A three-position switch sets where the distortion sits in the signal path: before the EQ, after the EQ, or Dry EQ, where only the dry signal mixed in by the Blend control passes through the EQ. The input jack has a switchable 10 dB pad for active basses or other high-output instruments.
On the connection side, the pedal has a quarter-inch input, a main output, a dry output and a balanced XLR output. The XLR has its own volume knob, a bypass-follow button and a ground-lift button for pin 1. Bypass is buffered, and the pedal runs from the supplied 9.6 V DC adapter.
Video
Tekniset tiedot
- Merkki
- Electro-Harmonix
- Malli
- Battalion
- Luokka
- Efektit ja pedaalit
Controls
- EQ bands
- Bass (below 200Hz), Lo Mid (280Hz), Hi Mid (750Hz), Treble (above 2kHz)
- Distortion controls
- Level, Blend, Drive, Tone
- Distortion routing
- Pre EQ / Post EQ / Dry EQ switch
- Compressor
- Amount knob, pushbutton with blue LED
- Noise gate
- Adjustable threshold (Gate knob)
- Master level
- Vol knob
- Footswitches
- Bypass (green LED), Drive (red LED)
Inputs
- Instrument input
- 1/4" jack
- Input pad
- Switchable -10dB
Outputs
- Main output
- 1/4" jack, dry or affected per bypass state
- Dry output
- 1/4" jack, unaffected signal
- Balanced output
- XLR jack
- XLR volume
- XLR Vol knob
- XLR bypass button
- Pushed in: XLR follows pedal bypass state
- Ground lift
- Button; pushed in keeps ground on XLR pin 1
Audio
- Circuit
- Analog
- Bypass
- Buffered Bypass
- Audio
- Mono
Power
- Power supply
- 9.6VDC-200mA power adapter included
- Current draw
- 100mA
Physical
- Dimensions
- 5.75 x 4.75 x 2.5 in
In the box
- Power adapter
- Included