Gray Channel
Dual-channel overdrive pedal with a green and a red channel, each with its own gain and level controls and a three-way clipping toggle. It suits guitarists who want two different drive voicings on one pedal. The maker lists it as no longer in production.
- Two overdrive channels: green and red
- 3 clipping modes per channel
- Separate channel select and on/off footswitches
- True bypass with relay-based switching
- 9 V DC, 2.1 mm negative centre, 45 mA
- No longer in production
Kuvat
6Ilmoitukset
Tästä mallista ei vielä ole ilmoituksia
Kun joku myy mallin Gray Channel, ilmoitukset ja myyntihistoria näkyvät täällä.
Myy samanlainenKuvaus
The pedal combines two hard-clipping overdrive channels, based on a classic gray-box overdrive circuit, with a bigger bass response than the original design. Each channel has a gain knob, a level knob and a three-position clipping toggle. A channel switch selects between the two, and a separate footswitch turns the effect on and off.
The green channel offers silicon diodes (bright, loud, with a tube-like break-up), germanium diodes (looser, with more low end and less output) or no clipping. The red channel offers LED clipping (loudest, cleanest and most touch sensitive), MOSFET clipping (most compressed, with a tighter crunch) or no clipping. In the no-clipping position each channel behaves as a clean boost until the gain passes about 1 o'clock, then saturates the op-amp into a loud, biting distortion.
The pedal is true bypass with electronic relay-based switching, so no audio passes when it is unpowered. It runs from a 9 V DC supply with a 2.1 mm negative-centre barrel connector and draws 45 mA. The maker recommends isolated pedal-specific power supplies and warns against higher voltages.
Video
Tekniset tiedot
- Merkki
- EarthQuaker Devices
- Malli
- Gray Channel
- Luokka
- Efektit ja pedaalit
Controls
- Green channel gain
- Adjusts the drive
- Green channel level
- Green knob, sets output level when green LED is lit
- Green channel clipping toggle
- Si (silicon), N (no clipping), Ge (germanium)
- Red channel gain
- Adjusts the drive
- Red channel level
- Red knob, sets output level when red LED is lit
- Red channel clipping toggle
- LED, N (no clipping), FET (MOSFET)
- Footswitches
- Channel switch (red/green) and activate switch
Audio
- Input impedance
- 500 kΩ
- Output impedance
- <1 kΩ
- Bypass
- True bypass, electronic relay-based switching
- Audio without power
- Audio will not pass without power
Power
- Power supply
- 9 V DC
- Connector
- 2.1 mm barrel, negative centre
- Current draw
- 45 mA
Physical
- Dimensions
- 4.65 x 3.65 x 2.25 in. (118 x 93 x 57 mm) with knobs
- Production status
- No longer in production