Arrows
Compact all-discrete analog pre-amp booster pedal for guitar, bass and keys with a single level control. It adds midrange push and tighter lows to drive pedals or brightens a signal on its own. No longer in production.
- All-discrete analog pre-amp booster
- Single Level control boosts or cuts the signal
- True bypass with relay-based switching
- 9 V DC, 2.1 mm negative center, 8 mA draw
- Handmade in Akron, Ohio
- No longer in production
Kuvat
7Ilmoitukset
Tästä mallista ei vielä ole ilmoituksia
Kun joku myy mallin Arrows, ilmoitukset ja myyntihistoria näkyvät täällä.
Myy samanlainenKuvaus
The Arrows is a single-knob boost built from discrete components. The Level control either boosts or cuts the signal, so it can add an extra gain stage in front of overdrive and fuzz pedals, tighten up bass-heavy fuzzes, brighten neck pickups, or lift a clean signal by itself. The voicing emphasises the midrange, firms up the low end and opens up the top end.
The circuit is fully analog and uses true bypass, switched by an electronic relay. Because of the relay, audio does not pass when the pedal is unpowered. Input impedance is 10 MΩ and output impedance is below 10 kΩ. Current draw is 8 mA.
The pedal runs from a standard 9 V DC supply with a 2.1 mm negative-center barrel connector and should not be run at higher voltages. Pedal-specific, isolated power supplies are recommended to avoid noise. It is handmade in Akron, Ohio, is covered by a limited lifetime warranty, and an operation manual is available for download.
Video
Tekniset tiedot
- Merkki
- EarthQuaker Devices
- Malli
- Arrows
- Luokka
- Efektit ja pedaalit
Controls
- Controls
- Level
- Level range
- Clockwise is loud, counterclockwise is quiet
- Function
- Pre-amp booster
Audio
- Circuit
- All-discrete, all analog
- Input impedance
- 10 MΩ
- Output impedance
- <10 kΩ
- Bypass
- True bypass
Switching
- Switching type
- Electronic relay-based
- Unpowered behavior
- Audio will not pass without power
Power
- Supply voltage
- 9 V DC
- Connector
- 2.1 mm barrel, negative center
- Current draw
- 8 mA
- Maximum voltage
- Do not run at higher voltages than 9 V
Physical
- Dimensions
- 4.75 x 2.50 x 2.25 in. (121 x 64 x 57 mm) with knobs
- Construction
- Handmade in Akron, Ohio
Software
- Operation manual
- Downloadable
- Warranty
- Limited lifetime warranty